HOLES AND POCKETS

Holes and pockets may be produced either by incorporation into the pattern (provided size limitations, draft requirements and direction of draw are satisfactory), or by insertion of separately made cores. These cores will give a flexibility of design to the casting, but generally at a higher production cost.

The limiting factors in casting holes and pockets are depth (L), degree of draft (d) and the narrowest dimension across the hole (a).

Because of the diverse nature of cored holes, it is best to consult your foundry on aspect ratios and core capabilities. Remarkable complexity can be achieved.

              
     
      St Paul Brass and Aluminum Foundry   -   954 West Minnehaha Avenue, St. Paul, MN  55104  -  (651)488-5567  -  (800)348-1649  -   Fax: (651)488-0908
      E-mail us for Free Video and Free Casting Design and Alloy Selection Guide or To Discuss Your Casting Project


St. Paul Brass and Aluminum Foundry is a charter honoree of the Inc 5000:

Search WWW Search spba.net

website creation by Tim Hartigan ©2007   Hosted by webhost4life